Be careful, as there are wires below connected to the buttons. The empty mini-pci slot Not much there, but that is how it looks. It has to move less than 1cm, just enough to release a series of tabs at the front end of the keyboard. The keyboard is held in place by two small screws under the panel. I assume the wire is for the antenna. First the panel with the power button and other buttons has to be removed.

Uploader: Kajikus
Date Added: 1 October 2014
File Size: 7.98 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 34068
Price: Free* [*Free Regsitration Required]

ASUS MN review – Engadget

Once it is inserted properly, push it down gently, until the two arms snap into place, locking the card. Once it is liberated from the two arms, the card can easily be removed completely.

Removing the keyboard Slide the keyboard slowly towards the display, applying moderate pressure. A useful assus, it helped me to install an Intel wireless card into an Iwill ii laptop. I used my swiss army knife. Install the necessary drivers and enjoy!

Loosening the keyboard Place the detached panel vertically towards the display not the way I have placed it on the photo: Beware of the band cable connecting the keyboard to the motherboard. I used an Atheros Cardbus card for a while, using the madwifi driver, but the laptop has only one PCMCIA slot, and it was a bit of a pain to have it always occupied.

Related Drivers  DRIVER: TOSHIBA SATELLITE C850 - B799

Test Qsus on the computer, log in as root and run the command lspci.

It was ok initially, but when I asjs the rest of my gear to Many thanks for this very useful guide through the installation of a new WLAN card. Are they going to be compatible with an AMD processor or do I have it all fubarred. The short story is that it can be done upgrading the builtin wireless card in the laptop, and it works.

Be careful not to damage the connector, which is very small. I assume the wire is for the antenna. Use some object to keep it upright, in the middle. Insert the new card Insert the card into the connectors, raising it a bit in the back.

Remove these two screws. There is a metallic knob at the bottom of the keyboard, that has to fit into the hole to the left of the mini-pci slot. It helps me too! The keyboard is held in place by two small screws under the panel.

ASUS M2400

You have the connectors in the front, the two arms that hold the card in place, and the black wire antenna. Removing the panel above the keyboard The first problem is to get to the socket so the card can be replaced.


Very helpful for replacing card on spartan laptop. Re-attach the keyboard Re-insert the keyboard, but placed approx. On the photo to the right the screwdriver is inserted in the currect position.

ASUS MN Memory & RAM Chip Upgrades – Lifetime Guarantee!

Once the keyboard is placed correctly, it can be slid back into place. I just bought a laptop for my parents with no integrated wireless. It has to move less than 1cm, just enough to release a series of tabs at the front end of the keyboard. The socket is below the keyboard, more or less in the middle. Make sure the taps slide correctly into the holes to the front.

Installing a new wireless mini-pci card in an Asus M2400N laptop

Place the panel a little bit too far to the right and slide it back into place. I did not have a card in it previously so logicaly it should be easy to open the 2 arms to the side. The long story, with photos of each step, is in the extended copy below.